Have you ever experienced the frustration of trying to keep your Polaris pool cleaner at the bottom of your pool? It can be a real headache, and can even lead to damage to your pool or the cleaner itself. However, there are a few simple steps you can take to ensure that your Polaris stays at the bottom of your pool and does its job effectively.
Check the Hose Length
The first thing you should do is check the length of your Polaris hose. If the hose is too long, it can cause the cleaner to float to the surface of the pool. To check the length of your hose, simply measure it from the cleaner to the furthest point in your pool, and then subtract a few inches. This will ensure that the hose is not too long, and that the cleaner will stay at the bottom of the pool.
Adjust the Water Pressure
Another reason your Polaris may not be staying at the bottom of your pool is due to water pressure. If the water pressure is too high, it can cause the cleaner to float to the surface. To adjust the water pressure, simply use the regulator valve on the hose to adjust the flow of water. Start with a low flow and gradually increase until the cleaner is moving effectively, but not floating to the surface.
Clean the Filter
If your Polaris filter is clogged or dirty, it can cause the cleaner to lose suction and float to the surface. To clean the filter, simply remove it from the cleaner and rinse it with a hose. If the filter is extremely dirty, you may need to soak it in a cleaning solution or replace it entirely.
Check for Air Leaks
If you have checked the hose length, adjusted the water pressure, and cleaned the filter, but your Polaris is still floating to the surface, you may have an air leak. Air leaks can occur anywhere in the hose or cleaner, and can cause the cleaner to lose suction and float to the surface. To check for air leaks, simply turn on the cleaner and inspect the hose and connections for any air bubbles. If you find a leak, you may need to replace the hose or tighten the connection.
Conclusion
Keeping your Polaris at the bottom of your pool is essential for effective cleaning and maintenance. By following these simple steps, you can ensure that your Polaris stays at the bottom of your pool and does its job effectively. Check the hose length, adjust the water pressure, clean the filter, and check for air leaks to keep your pool cleaner working properly.
Recommended for you: How Many Chlorine Pucks To Use?
FAQs for “How Do I Make Polaris Stay At The Bottom Of My Pool?”
1. Why does my Polaris keep floating to the surface?
Answer: There could be several reasons why your Polaris is floating to the surface. One of the most common reasons is that the water pressure is too high. Try adjusting the water pressure to see if this solves the problem.
2. How can I adjust the water pressure on my Polaris?
Answer: To adjust the water pressure on your Polaris, locate the pressure relief valve on the pool pump. Turn the valve counterclockwise to reduce the pressure or clockwise to increase it. You can also adjust the water flow rate by turning the flow control valve on the Polaris.
3. What else can I do to keep my Polaris at the bottom of the pool?
Answer: In addition to adjusting the water pressure, you can try adding weights to the Polaris to keep it at the bottom of the pool. You can also adjust the angle of the Polaris to ensure that it is pointing downward. Finally, make sure that the Polaris is properly balanced and that the wheels are not worn out, as this can also cause the Polaris to float to the surface.
Related article: Why Is My Automatic Pool Vacuum Not Moving?